User Manual

FCC DRAFT
Security
Device security
Select Menu > Tools > Settings > Security > Phone and
SIM.
You can modify the security settings for the PIN code,
automatic lock, and SIM card change, and change codes
and passwords.
Avoid using codes that are similar to emergency numbers
to prevent accidental dialing of the emergency number.
Codes are shown as asterisks. When you change a code,
enter the current code, then the new code twice.
Define security settings
To define device and SIM card settings, select a setting and
Options > Change.
When calls are limited to closed user groups, calls may be
possible to the official emergency number programmed
into your device.
Define the following settings:
• PIN code request — Select On to request that the PIN
code is entered each time the device is switched on.
This setting cannot be changed if the device is
switched off. Some SIM cards do not allow turning off
the PIN code request.
• PIN code — Change the PIN code. The PIN code must
be 4 to 8 numbers long. The PIN code protects your SIM
card against unauthorized use and is provided with
the SIM card. After three consecutive incorrect PIN code
entries, the PIN code is blocked, and you need to use
the PUK code to unblock it before you can use the SIM
card again.
• PIN2 code — Change the PIN2 code. The PIN2 code
must be 4 to 8 numbers long. The PIN2 code is required
to access some functions of the device and is provided
with the SIM card. After three consecutive incorrect
PIN2 code entries, the PIN2 code is blocked, and you
need to use the PUK2 code to unblock it before you can
use the SIM card again.
• Autolock period — Set a time-out after which the
device is automatically locked and can be used only if
the correct lock code is entered. Enter a number for the
time-out in minutes, or select None to turn off the
autolock period. When the device is locked, you can
still answer incoming calls and calls may still be
possible to the official emergency number
programmed into your device.
• Lock code — Change the lock code. The new code can
be 4-256 characters long. Numeric and uppercase and
lowercase alphabetic characters can be used. The
device notifies you if the lock code is not properly
formatted. The device remembers the previously used
lock codes and prevents you from using the same lock
code several times. The preset code is 12345. To avoid
unauthorized use of your device, change the lock code.
Keep the new code secret and in a safe place separate
from your device.
112
Security
file:///C:/USERS/MODEServer/mehowell/12100235/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 112 Mar 9, 2006 5:37:29 PM