User Manual

FCC DRAFT
3. Replace the battery cover.
4. To remove the memory card, remove the battery cover
and push the memory card into the device to activate
the release mechanism. Then, gently pull the card out
of your device.
Important: Do not remove the MultiMediaCard
(MMC) in the middle of an operation when the card is
being accessed. Removing the card in the middle of
an operation may damage the memory card as well
as the device, and data stored on the card may be
corrupted.
Switch on your device
1. To switch the device on, press the power key.
2. If the device asks for a PIN code, lock code, or security
code, enter the code, and select OK.
3. To switch the device off, press the power key.
Tip: When you switch the device on, it may
recognize the SIM card provider and configure
the correct text message, multimedia message,
and GPRS settings automatically. If not, contact
your service provider for the correct settings, or
use the Sett. wizard application.
The device can be used without the network-dependent
phone functions when a SIM card is not inserted or when
the Offline profile is selected.
The picture shows the
location of the power
key.
Charge the
battery
1. Connect the charger to a wall outlet.
2. Connect the charger to the bottom of the device. If you
have a battery charger adapter, connect the charger
to the adapter, and the adapter to the bottom of the
device.
3. Connect the power cord to the battery charger
adapter. The battery indicator bar starts scrolling on
the display. If the battery is completely discharged, it
may take a few minutes before the charging indicator
is shown. The device can be used while charging.
11
Get started
file:///C:/USERS/MODEServer/mehowell/12100235/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 11 Mar 9, 2006 5:37:29 PMfile:///C:/USERS/MODEServer/mehowell/12100235/rm-88_texas/en/issue_1/rm-88_texas_en_1.xml Page 11 Mar 9, 2006 5:37:29 PM