User Manual
Table Of Contents
- Nokia E75 User Guide
- Contents
- Safety
- Quick start guide
- Nokia E75 - The basics
- Personalisation
- New from Nokia Eseries
- Messaging
- Phone
- Internet
- Travelling
- Positioning (GPS)
- Maps
- Maps
- Network positioning
- Move on a map
- Display indicators
- Find locations
- Plan a route
- Save and send locations
- View your saved items
- Navigate to the destination
- Walk to your destination
- Drive to your destination
- Traffic information
- Travel guides
- Maps settings
- Internet settings
- Navigation settings
- Route settings
- Map settings
- Update maps
- Nokia Map Loader
- Shortcuts
- Nokia Office Tools
- Media
- Connectivity
- Security and data management
- Settings
- General settings
- Telephone settings
- Connection settings
- Access points
- Packet data (GPRS) settings
- WLAN settings
- Advanced WLAN settings
- WLAN security settings
- WEP security settings
- WEP key settings
- 802.1x security settings
- WPA security settings
- Wireless LAN plugins
- Session initiation protocol (SIP) settings
- Edit SIP profiles
- Edit SIP proxy servers
- Edit registration servers
- Configuration settings
- Restrict packet data
- Application settings
- Shortcuts
- Glossary
- Troubleshooting
- Battery
- Care and maintenance
- Additional safety information
- Index
To disable the A-GPS service, select Menu >
#Applications > #GPS > GPS data and Options >
Positioning settings > Positioning methods >
Assisted GPS > Disable.
You must have an internet access point defined in the
device to retrieve assistance data from the Nokia A-GPS
service over a packet data connection. The access point
for A-GPS can be defined in positioning settings. A
wireless LAN (WLAN) access point cannot be used for
this service. Only a packet data internet access point
can be used. Your device asks you to select the internet
access point when GPS is used for the first time.
Hold your device correctly
The GPS receiver is located on the back of the device.
When using the receiver, make sure that you do not
cover the antenna with your hand.
Establishing a GPS connection may take
from a couple of seconds to several minutes.
Establishing a GPS connection in a vehicle
may take longer.
The GPS receiver draws its power from the
device battery. Using the GPS receiver may
drain the battery faster.
Tips on creating a GPS
connection
If your device cannot find the satellite signal, consider
the following:
• If you are indoors, go outdoors to receive a better
signal.
• If you are outdoors, move to a more open space.
• Ensure that your hand does not cover the GPS
antenna of your device.
• If the weather conditions are bad, the signal
strength may be affected.
• Some vehicles have tinted (athermic) windows,
which may block the satellite signals.
Check satellite signal status
To check how many satellites your device has found,
and whether your device is receiving satellite signals,
select Menu > #Applications > #GPS > GPS data
and Position > Options > Satellite status.
If your device has found
satellites, a bar for each
satellite is shown in the
satellite info view. The
longer the bar, the stronger
the satellite signal. When
your device has received
enough data from the
satellite signal to calculate the coordinates of your
location, the bar turns blue.
Initially, your device must receive signals from at least
four satellites to be able to calculate the coordinates of
your location. When the initial calculation has been
made, it may be possible to continue calculating the
coordinates of your location with three satellites.
However, the accuracy is generally better when more
satellites are found.
86










