User's Guide

Positioning
76
position. To enter the position information manually,
select Enter manually.
To edit or add information to a saved landmark (for
example, a street address), scroll to a landmark, and press
. Scroll to the desired field and enter the information.
To view the landmark on the map, select Options > Show
on map. To create a route to the location, select Options >
Navigate using map.
You can sort your landmarks into the preset categories,
and create new categories. To edit and create new
landmark categories, press in Landmarks, and select
Options > Edit categories.
To add a landmark to a category, scroll to the landmark in
Landmarks, and select Options > Add to category. Scroll
to each category to which you want to add the landmark,
and select it.
To send one or several landmarks to a compatible device,
select Options > Send. Your received landmarks are placed
in the Inbox folder in Messaging.
GPS data
Press , and select Tools > GPS data. GPS data is
designed to provide route guidance information to a
selected destination, position information about your
current location, and traveling information, such as the
approximate distance to the destination and approximate
duration of travel.
The coordinates in the GPS are expressed in degrees and
decimal degrees format using the international WGS-84
coordinate system.
To use GPS data, the GPS receiver of your device must
receive position information from at least three satellites
to calculate the coordinates of your location.
Route guidance
To use route guidance, select Navigation. Start the route
guidance outdoors. If started indoors, the GPS receiver may
not receive the necessary information from the satellites.
Route guidance uses a rotating compass on the device
display. A red ball shows the direction to the destination,
and the approximate distance to it is shown inside the
compass ring.
Route guidance is designed to show the straightest route
and the shortest distance to the destination, measured in
a straight line. Any obstacles on the route, such as
buildings and natural obstacles, are ignored. Differences in
altitude are not taken into account when calculating the
distance. Route guidance is active only when you move.
To set your trip destination, select Options > Set
destination and a landmark as the destination, or enter
Draft