User Manual

ADDITIONAL SAFETY INFORMATION
114
Do not store the device in cold areas. When the device
returns to its normal temperature, moisture can form
inside the device and damage electronic circuit boards.
Do not attempt to open the device other than as
instructed in this guide.
Do not drop, knock, or shake the device. Rough handling
can break internal circuit boards and fine mechanics.
Do not use harsh chemicals, cleaning solvents, or strong
detergents to clean the device.
Do not paint the device. Paint can clog the moving parts
and prevent proper operation.
Use a soft, clean, dry cloth to clean any lenses (such as
camera, proximity sensor, and light sensor lenses).
Use only the supplied or an approved replacement
antenna. Unauthorised antennas, modifications, or
attachments could damage the device and may violate
regulations governing radio devices.
All of the above suggestions apply equally to your device,
battery, charger, or any enhancement. If any device is not
working properly, take it to the nearest authorized service
facility for service.
ADDITIONAL SAFETY INFORMATION
Operating environment
Remember to follow any special regulations in force in any
area and always switch off your device when its use is
prohibited or when it may cause interference or danger. Use
the device only in its normal operating positions.
This device meets RF exposure guidelines when used either in
the normal use position against the ear or when positioned at
least 5/8 inch (1.5 cm) away from the body. When a carry
case, belt clip or holder is used for body-worn operation, it
should not contain metal and should position the device the
above-stated distance from your body.
In order to transmit data files or messages, this device
requires a good quality connection to the network. In some
cases, transmission of data files or messages may be delayed
until such a connection is available. Ensure the above
separation distance instructions are followed until the
transmission is completed.
Medical devices
Operation of any radio transmitting equipment, including
wireless phones, may interfere with the functionality of
inadequately protected medical devices. Consult a physician or
the manufacturer of the medical device to determine if they
are adequately shielded from external RF energy or if you have
any questions. Switch off your device in health care facilities
when any regulations posted in these areas instruct you to do
so. Hospitals or health care facilities may be using equipment
that could be sensitive to external RF energy.
Pacemakers Pacemaker manufacturers recommend that a
minimum separation of 6 in. (15.3 cm) be maintained between
a wireless phone and a pacemaker to avoid potential
interference with the pacemaker. These recommendations are
consistent with the independent research by and
recommendations of Wireless Technology Research. Persons
with pacemakers should:
R0915_en.book Page 114 Wednesday, September 15, 2004 12:14 PM