User Manual

Wireless Platforms

CM/BU 4 (10)

4 Unpacking

The modules are shipped in either single module clamshell or 100 module trays

4.1 Individual Module Clamshell

Figure 1: Representative* example of individual module Single clamshell with RD-1/RD-2 module

The module should only be removed from the clamshell package directly before insertion into the host laptop. The

packaging is opened by holding the middle tab in between the thumb and forefinger of one hand and gently prising

one of the outer tabs using the other thumb and forefinger. This process should be repeated for the other outer

tab. Once both of the outer tabs have been freed from the centre tab then the packing should be bent back along

the hinge line until flat. Holding one hand out flat the packaging can be place open side down on the palm of the

hand and gentle pressure applied to the back of the package until the module pops out into the palm, the

packaging should then be place to one side. The module should then be held prior to installation in accordance

with the General Handling guidance given in paragraph 5.1

4.2 100 Module Trays

Figure 2: Representative* example of 100 module clamshell with RD-1/RD-2 modules