User's Guide

Table Of Contents

away from the body. When a carry case, belt clip, or holder is used for body-worn operation, it should not contain metal and

should position the device at least 5/8inch (1.5 cm) away from your body.

In order to transmit data files or messages, this device requires a quality connection to the network. In some cases,

transmission of data files or messages may be delayed until such a connection is available. Ensure the above separation

distance instructions are followed until the transmission is completed.

Emergency calls

Important: Wireless phones, including this device, operate using radio signals, wireless networks, landline

networks, and user-programmed functions. Because of this, connections in all conditions cannot be guaranteed.

You should never rely solely on any wireless device for essential communications like medical emergencies.

To make an emergency call:

1. If the device is not on, switch it on. Check for adequate signal strength.

Some networks may require that a valid SIM card is properly inserted in the device.

2. Press

as many times as needed to clear the display and ready the device for calls.

3. Key in the official emergency number for your present location. Emergency numbers vary by location.

4. Press the

key.

If certain features are in use, you may first need to turn those features off before you can make an emergency call. Consult

this guide or your service provider for more information. When making an emergency call, give all the necessary information

as accurately as possible. Your wireless device may be the only means of communication at the scene of an accident. Do not

end the call until given permission to do so.

Certification Information (SAR)

THIS DEVICE MEETS THE GOVERNMENT'S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.

Your mobile device is a radio transmitter and receiver. It is designed and manufactured not to exceed the limits for exposure

to radio frequency (RF) energy adopted by the governments of the USA through the Federal Communications Commission

(FCC) and Canada through Industry Canada (IC). These limits establish permitted levels of RF energy for the general

population. The guidelines are based on standards that were developed by independent scientific organizations through

periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure

the safety of all persons, regardless of age and health.

The exposure guidelines for mobile devices employ a unit of measurement known as the Specific Absorption Rate or SAR.

The SAR limit adopted by the USA and Canada is 1.6 watts/kilogram (W/kg) averaged over one gram of tissue. The limit

incorporates a substantial margin of safety to give additional protection for the public and to account for any variations in

measurements. Tests for SAR are conducted using standard operating positions with the device transmitting at its highest

certified power level in all tested frequency bands. The actual SAR level of an operating device can be well below the

maximum value because the device is designed to use only the power required to reach the network. That amount changes

depending on a number of factors such as how close you are to a network base station.

The highest SAR value reported to the FCC and IC for this device type when tested for use at the ear is 0.92 W/kg, and when

properly worn on the body is 1.53 W/kg. SAR information on file with the FCC can be found under the Display Grant section of

www.fcc.gov/oet/fccidafter searching on FCC ID PDNRA-2. SAR values reported in other countries may vary depending on

differences in reporting and testing requirements and the network band. Additional SAR information may be provided under

product information at www.nokia.com.

Additional safety information