User Manual

Getting started
9
If the next letter is located on the same key as the present one, wait
until the cursor appears; then enter the letter.
If you make a mistake, press the clear key to remove the incorrect
character.
To enter an upper case letter, press the mark key, and select Upper case
mode. To enter a lower case letter, press the mark key again, and select
Lower case mode. To enter a number, press the mark key, and select
Number mode.
To insert a space, press the 0 key.
The most common punctuation marks are available under the 1 key.
Press the * key to open a list of special characters. Scroll to the desired
character, and press Select.
2. Getting started
■ Connecting the Image Album to a TV
Note: Always switch the device off and remove from the power
supply before connecting or modifying the cables.
1 Connect the RCA cable to the RCA connector on the back panel of
the Image Album. See “Figure 5” on page 10.
Plug the yellow video cable plug to the yellow video connector of the
Image Album, and the red and white audio cable plugs to the red and
white audio connectors of the Image Album.
2 Connect the other end of the RCA cable to the RCA connector of your
TV, or use the SCART adapter to connect the RCA cable to the SCART
connector of your TV.
Plug the yellow video cable plug to the video connector of the TV,
and the red and white audio cable plugs to the audio connectors of
your TV. See the user guide of your TV for instructions.
3 Plug the power supply into the mains outlet and connect the other
end to the power connector of the Image Album.
Image_album_0107.fm Page 9 Thursday, July 1, 2004 11:50 AM