User Manual

Getting started
10
Figure 5
4 The standby light blinks green. Wait until the Image Album is in
standby mode and the standby light is red.
5 Switch on your TV, and select the correct input. See the user guide
of your TV for instructions.
■ Switching on the Image Album
1 Insert the batteries into the remote control.
2 Press the power key on the remote control to switch on the Image
Album. The standby light blinks green until the Image Album is on
3 Use the scroll key to select your language from the list, and press OK
with the left selection key.
4 Use the character keys on the remote control to set the current date,
and press OK.
5 Use the character keys on the remote control to set the current time,
and press OK.
The Image Album is now ready for use.
If the TV picture quality is poor, check that the position of the NTSC/PAL
switch on the back panel of the Image Album corresponds to your TV
standard, see “Figure 2” on page 7. If you need to change the position of
the switch, restart the Image Album after the change.
Image_album_0107.fm Page 10 Thursday, July 1, 2004 11:50 AM