User Manual

[ 81 ]
12
Note: This profile is available only when your phone is connected
to a headset, loopset or to an approved car kit. This feature applies
only to voice calls.
1 Press Menu 4 5 (Settings > Accessory settings).
2 Scroll to Headset, Handsfree, TTY or Loopset then press Select
.
3 Scroll to Automatic answer, then press Select.
4 Scroll to On and press OK.
Set up the loopset profile
The LPS-3 Loopset gives people with T-coil equipped hearing aids the
ability to make and receive calls without noise interference.
Important: Refer to the booklet that comes with the LPS-3 for
complete instructions and safety information.
1 Plug the loopset jack into the bottom of your phone.
2 Press Menu 4 6 3 (Settings > Accessory settings > Loopset).
3 Scroll to Use loopset, then press Select.
4 Scroll to Yes, then press OK.
Note: The headset is the default accessory. If you follow steps 1 - 4
above, you set the loopset as the default accessory recognized by
your phone.
Set up car profile
If you are using your phone with a Nokia-approved car kit, you can set
lights to On (lights stay on) or Automatic (after 15 seconds, lights turn
off until the next key is pressed or the phone rings).