User's Manual

Menu functions
80
• Data call speed - Select the speed you want to use, or select
Automatic. Automatic is available only if the current selected data
call type is Analogue. The actual data call speed depends on the
service provider.
• Login type - Select Manual or Automatic.
• User name - Key in the user name and press OK.
• Password - Key in the password and press OK.
Settings when
GPRS
is the selected data bearer
• GPRS access point - Key in the access point name and press OK.
An access point name is needed to establish a connection to a GPRS
network. You obtain the access point name from your network
operator or service provider.
• IP address - Key in the address, press for a dot , and press OK. You
obtain the IP address from your network operator or service provider.
• Authentication type - Select Secure or Normal. If you select
Automatic, the login type uses the user name and password keyed in
the following settings. If you select Manual, the login information is
required when establishing a connection.
• Login type - Select Manual or Automatic.
• User name - Key in the user name and press OK.
• Password - Key in the password and press OK.
Making a connection to a WAP service
Firstly, make sure that the service settings of the WAP service you want
to use are activated. To activate the settings:
•Press Menu, and select Services and Settings. Select Active service
settings and scroll to the set you want to activate and press Activate.
Secondly, make a connection to the WAP service. There are three ways
to connect:
npl-2_en1_1.fm Page 80 Monday, September 2, 2002 2:39 PM