User's Manual

Menu functions

Keying in the service settings manually

1. Press Menu, and select Services, and Settings.

2. Select Active service settings.

You need to activate the set where you want to save the service

settings. A set is a collection of settings needed for making a

connection to a WAP service.

3. Scroll to the set you would like to activate and press Activate.

4. Select Edit active service settings.

Select each of the following service settings one by one and key in all

the required settings.

• Settings' name - Key in the new name for the connection set and

press OK.

• Homepage - Key in the homepage address of the WAP service

that you want to use, press for a dot, and press OK.

• Session mode - Select Permanent or Temporary.

• Connection security - Select On or Off.

When the connection security is On, the phone tries to use a

secure connection with the WAP service. If a secure connection is

not available, the connection will not be made. If you wish to

connect anyway, with a non-secure connection, you must set the

connection security to Off.

• Data bearer - Select GSM data or GPRS. Settings for the selected

bearer, see Settings when GSM data is the selected data bearer

and Settings when GPRS is the selected data bearer below.

For pricing, connection speed and other information, contact

your network operator or service provider.

Settings when

GSM data

is the selected data bearer

• Dial-up number - Key in the phone number and press OK.

• IP address - Key in the address, press for a dot, and press OK. You

obtain the IP address from your network operator or service provider.

• Authentication type - Select Secure or Normal.

• Data call type - Select Analogue or ISDN.

npl-2_en1_1.fm Page 79 Monday, September 2, 2002 2:39 PM