User's Manual

2
To install IntelliPoint software (Macintosh)
If your pointing device has a Universal Serial Bus (USB) connector, it can be
used with a Macintosh computer.
• Insert the Microsoft IntelliPoint compact disc into the computer’s CD-ROM
drive, double-click the IntelliPoint Installer icon, and then follow the on-screen
instructions.
After installation is complete, restart your computer if prompted to do so.
Insert the Batteries
Whenever you insert batteries, always make sure both of them are new. Alkaline
batteries are recommended, and two alkaline batteries are included in the
package.
To preserve battery life, the pointing device automatically enters power saving
mode when not in use, so there is no need for a power switch.
1 Turn the pointing device upside down, and then remove the battery compart-
ment cover.
2 Insert the batteries, making sure to properly orient the positive (+) and
negative (–) ends as specified by the battery compartment labels.
3 Close the battery compartment cover.
Before boarding any aircraft, remove the batteries from the wireless pointing
device. The wireless pointing device can emit radio frequency (RF) energy,
similar to a cellular telephone, whenever batteries are installed and the mouse
is activated either by touch or button press.
2
X08-75976_Mnl_Ret_Wireless_Pointing_Devices.p65 3/6/2002, 9:49 AM2