User`s guide

MN-700 Base Station Configuration Guide 13
Wide Area Network Settings
Your Internet Service Provider (ISP) provides the settings that enable you to establish an Internet connection on
your network. These are your wide area network (WAN) settings. These settings vary, depending on whether your
ISP account provides a static IP address, a dynamic Internet connection, or a Point-to-Point Protocol over Ethernet
(PPPoE) connection.
If you did not run the Setup Wizard to configure your base station, you can establish your Internet connection by
entering the settings provided by your ISP on the Wide Area Network page of the Base Station Management Tool,
shown in the following illustration. You can also update these settings, if, for example, you change ISPs or settings
for your current account change.
If you need assistance identifying your Internet connection settings, see Broadband Network Utility Help.
You also have the option to disable your network Internet connection from the Wide Area Network page,
if necessary.
The following sections describe each type of Internet connection and how to configure your base station for
that option.