User's Manual

Tap the NFC areas of the speaker and the device together. The speaker connects to the device

automatically. If the speaker is switched off, it switches on before connecting.

Tip: To reconnect a previously paired device, tap the NFC areas of the device and the speaker

together. The speaker closes the active connection before reconnecting.

For details on NFC, see the user guide of your device.

To close the connection, tap the NFC areas together again.

Clear the pairings

If you want to clear all the pairings and settings, restore your speaker to the factory settings.

Make sure the speaker is switched off.

1. Press and hold the multifunction key for about 5 seconds to activate pairing mode.

2. Press and hold the multifunction key for more than 8 seconds.

The battery indicator light flashes green and red and the speaker goes back into pairing mode.

After you’ve cleared the pairings, you must pair the speaker before you can use it again.

If you want to pair with the same device after clearing the pairings, also clear that pairing in your

device before pairing again.

Connect your speaker manually

If your device doesn’t support Bluetooth, you can use a standard audio cable (3.5 mm) to connect

your speaker.

Make sure your speaker is switched on.

Connect a standard audio cable (3.5 mm) to the audio connector in your speaker and in your device.

When you connect your speaker using a cable, Bluetooth is switched off automatically, and the

Bluetooth indicator light stays on.

When you disconnect the cable, Bluetooth is switched on and the speaker connects automatically to

the last connected Bluetooth device.