User's Manual

Note If you are running Windows 98, you may be prompted to insert the Windows 98

CD-ROM after plugging the rectangular USB connector into your computer’s USB port. The

required USB driver is located in the Win98 folder of the Windows 98 CD-ROM.

Important Before using this product, read about the potential for radio interference in the

topic titled “Radio and TV interference regulations” in the User's Guides installed with the

software.

Test the Keyboard and Mouse

Try using the keyboard and mouse to make sure that they are working. If either device does

not work as expected, make sure the following procedures were completed as specified

earlier in these instructions:

• New batteries are inserted and positioned correctly for each device

• The receiver is properly connected to the computer

• Both devices are properly positioned and there are no nearby items that might cause

interference

If the keyboard or mouse is still not working, try changing the wireless connection channel

for the device. Changing the wireless connection channel is useful if your wireless device

has more than one channel and you are experiencing interference.

To change the wireless connection channel

• Press the button on the bottom of the wireless keyboard or mouse.

If changing the channel does not solve the problem, you may need to reconnect the device

to the receiver. To avoid potential interference, each wireless keyboard and mouse trans-

mits data using a unique code, which the receiver is preset to accept. In rare circum-

stances, a device may need to be reconnected with the receiver to work properly.

To reconnect the keyboard or mouse to the receiver

1 Make sure that the device and receiver are positioned as specified earlier in these

instructions.

2 Press the button on the top of the wireless receiver.

The receiver lights blink to indicate that it is in “connect” mode.

3 Press the button on the bottom of the device.

The wireless device may not work for a few seconds until the reconnection process is

completed.

Note You can only reconnect one device for each press of the receiver button, so repeat as

necessary for the other device.

If reconnecting the device to the receiver does not solve the problem, refer to the User’s

Guides installed with the keyboard or mouse software for additional troubleshooting

information.

Xxx-xxxxx_Mnl_Ret_Wireless_Suites.p65 3/6/2002, 9:55 AM3