HS-106W_UG_en1_with_FCC&IC_notice.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 2 Monday, March 10, 2008 4:55 PM DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HS-106W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/declaration_of_conformity/. © 2008 Nokia. All rights reserved.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 3 Monday, March 10, 2008 4:55 PM Export controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 4 Monday, March 10, 2008 4:55 PM Contents 1. Introduction ......................... 5 Bluetooth wireless technology........... 5 2. Get started ........................... 7 Overview................................................... 7 Chargers.................................................... 7 Charge the battery ................................ 8 Switch the headset on or off.............. 9 Pair the headset .....................................
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 5 Monday, March 10, 2008 4:55 PM Introduction 1. Introduction With the Nokia Bluetooth Headset BH-703, you can make and receive calls while on the move. You can use the headset with compatible devices that support Bluetooth wireless technology. Read this user guide carefully before using the headset. Also, read the user guide for your mobile device that you connect to the headset. It provides important safety and maintenance information. Check www.nokia.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 6 Monday, March 10, 2008 4:55 PM Introduction subject to interference from obstructions (shown in light grey) or other electronic devices. The headset is compliant with the Bluetooth Specification 2.1 + EDR supporting the following profiles: Headset Profile 1.1 and Hands-Free Profile 1.5. Check with the manufacturers of other devices to determine their compatibility with this device.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 7 Monday, March 10, 2008 4:55 PM Get started 2. Get started ■ Overview The headset contains the following parts: 1. Indicator light 2. Charger connector 3. Multifunction key 4. Touch-sensitive area for volume adjustment 1 2 5 3 4 6 5. Earpiece with a changeable earplug 7 6. Earloop 7. Microphone Before you can start using the headset, you must charge the battery and pair the headset with a compatible device. Parts of the headset are magnetic.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 8 Monday, March 10, 2008 4:55 PM Get started Warning: Use only chargers approved by Nokia for use with this particular enhancement. The use of any other types may invalidate any approval or warranty, and may be dangerous. When you disconnect the power cord of any enhancement, grasp and pull the plug, not the cord. ■ Charge the battery Before charging the battery, carefully read “Battery information,” p. 17. 1. Connect the charger to a wall outlet. 2.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 9 Monday, March 10, 2008 4:55 PM Get started ■ Switch the headset on or off To switch on, press and hold the multifunction key until the headset beeps and the indicator light turns on. When the headset can be connected to a paired device, the indicator light slowly flashes green. When the headset is connected to a paired device and is ready for use, the indicator light slowly flashes blue.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 10 Monday, March 10, 2008 4:55 PM Get started 5. Enter the passcode 0000 to pair and connect the headset to your device, if your device asks you to do so. In some mobile devices, you may need to make the connection separately after pairing. See the user guide of your device for details. You only need to pair the headset with your device once.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 11 Monday, March 10, 2008 4:55 PM Get started • Ensure that the headset is charged, switched on, and paired with your device. • Ensure that the Bluetooth feature is activated on your device. • Ensure that the headset is within 10 metres (33 feet) of your device and that there are no obstructions between the headset and the device, such as walls, or other electronic devices.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 12 Monday, March 10, 2008 4:55 PM Basic use 3. Basic use ■ Change the earplug The headset may be provided with different sized earplugs. Select the earplug that fits the best and is the most comfortable for your ear. When you insert the earpiece into your ear, do not push the earplug deep into the outer auditory canal because in that case the volume may sound too loud.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 13 Monday, March 10, 2008 4:55 PM Basic use To use the headset with the earloop, insert the earloop into the small opening at the back of the headset (2). To wear the headset on the right ear, rotate the earloop so that the loop is to the right of the Nokia logo. Slide the earloop over your ear (3), and push or pull the earloop to set its length. Gently push the earpiece into your ear, and set the headset so that it points toward your mouth (4).
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 14 Monday, March 10, 2008 4:55 PM Basic use ■ Carry the headset in the strap The headset may be provided with a carrying strap. You can use the strap to wear the headset around your neck. To attach the headset to the strap, insert the headset into the catch at the end of the strap. To detach the headset, pull it from the catch. ■ Calls To make a call, use your mobile device in the normal way when the headset is connected to the device.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 15 Monday, March 10, 2008 4:55 PM Basic use To put a call on hold (or to return to a call on hold), press and hold the multifunction key. To answer a waiting call and put the current call on hold, press and hold the multifunction key. To answer a waiting call and end the current call, briefly press the multifunction key. To switch between the active call and the call on hold, press and hold the multifunction key for about 2 to 3 seconds.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 16 Monday, March 10, 2008 4:55 PM Basic use ■ Switch the call between the headset and mobile device To switch the call from the headset to a connected device, press and hold the multifunction key for about 4 seconds (the headset switches off), or use the keys of your device. To switch the call back to the headset, switch on the headset (and connect it to your paired device), or press and hold the multifunction key for about 2 to 3 seconds (when the headset is on).
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 17 Monday, March 10, 2008 4:55 PM Battery information 4. Battery information This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 18 Monday, March 10, 2008 4:55 PM Battery information amount of time that the device is turned on and in the standby mode will affect its talk time.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 19 Monday, March 10, 2008 4:55 PM Care and maintenance Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 20 Monday, March 10, 2008 4:55 PM Care and maintenance Disposal The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies to the European Union and other locations where separate collection systems are available.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 21 Monday, March 10, 2008 4:55 PM FCC/Industry Canada notice FCC/Industry Canada notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference; and 2. This device must accept any interference received, including interference that may cause undesired operation.
HS-106W_UG_en1_with_FCC&IC_notice.fm Page 22 Monday, March 10, 2008 4:55 PM FCC/Industry Canada notice not expressly approved by Nokia could void the user's authority to operate the equipment.
