Cark 112 Installation Guide 11.10.
Introduction This installation guide has been prepared to provide the basic information necessary to install the car kit. This guide is not intended to be definitive, because different types and models of vehicles will require different installation work. The information given is for general guidance only. The terms of warranty demand that this car kit be installed by an experienced installer and only genuine Nokia parts are used.
WARNINGS 1. ENSURE THAT THE VEHICLE’S BATTERY IS DISCONNECTED BEFORE YOU START THE INSTALLATION PROCEDURE, AND THAT IT REMAINS DISCONNECTED DURING THE PROCEDURE. 2. DO NOT SMOKE OR USE OPEN FLAMES WHEN WORKING NEAR THE VEHICLE’S FUEL SYSTEM. 3. ENSURE THAT THE VEHICLE’S ELECTRICAL CABLES, HYDRAULIC LINES, FUEL LINES, AND SAFETY EQUIPMENT ARE NOT DAMAGED DURING INSTALLATION. 4. ENSURE THAT NORMAL CONTROL AND OPERATION OF THE VEHICLE IS NOT IMPAIRED BY THE INSTALLATION, PARTICULARLY THE BRAKES AND STEERING.
Unpacking Carefully unpack the equipment and ensure that the following items are present.
Wireless HF Unit HFW-1 INTERNAL BLUETOOTH ANTENNA SPEAKER MIC REMOTE PHONE DC The HFW-1 is used in a fixed car installation and it offers a wireless handsfree function, a fast charging function when a phone is connected into it by a charging cable (phone specific, not supplied with CARK-112) and a wireless connection to external devices. The HFW-1 unit is attached to the vehicle interior using the mounting plate MKU-1. HFW-1 is secured to MKU-1 with a screw (included with MKU-1).
Do not install the HFW-1 unit in a metal casing (or similar location) that can prevent the unit from transmitting radio frequencies. Aim the internal Bluetooth antenna (see picture) towards the user (Bluetooth phone). Mounting Plate MKU-1 MKU-1 is a fixed position mounting plate. It is used to attach Wireless HF Unit (HFW-1) to the vehicle. Remote Control Button CUW-2 The Remote Control Button (CUW-2) allows convenient operation of the phone.
To attach the Remote Control Button: 1. Detach the two grip pads from each other. 2. Peel off the protective sheet (pad with soft fabric) from the adhesive side and attach the pad to the desired location in the car. Make sure the surface where you attach this pad is dry and clean from dirt and dust. 3. Peel off the protective sheet (pad with rugged fabric) from the adhesive side and attach the pad to the bottom of the Remote Control Button. 4.
Power Cable PCU-4 The power cable connects the wireless handsfree unit HFW-1 to the vehicle’s power supply (DC socket). The red wire must be connected to the + voltage on the vehicle’s power supply via the supplied fused connector. The black wire must be attached to a good negative GND connection. The blue ignition sense (IGNS) wire is connected to +12 V voltage con trolled by the vehicle’s ignition key via the supplied fused connector. See section "Ignition Sense".
key. Do not connect it directly to the high voltage sections of the ignition circuit. Car Radio Muting CRM The car kit offers a feature that can mute the car radio automatically during a conversation. The car radio muting feature is based on a grounded line, so it means that in standby, the yellow wire (CRM) is not grounded and car radio works normally, but during a call, line is grounded and car radio is muted.
11.10.2001 10:25 Nokia and Nokia Connecting People are registered trademarks of Nokia Corporation. Copyright © 2001 Nokia Corporation. All rights reserved.
