User's Manual
Table Of Contents
- Contents
- For your safety
- Quick start
- 1. Introduction
- 2. Get started
- 3. Basic use
- 4. Settings
- 5. Troubleshooting
- 6. Installation
- Care and maintenance
- Additional safety information
- FCC/Industry Canada notice
Installation
41
Installation using the power cable CA-153P and direct
input cable CA-161
In this setup, the junction box is connected to the car radio with the
power cable CA-153P and the direct input cable CA-161, and the car
radio speakers are used for calls.
1. Connect the wires of the power cable CA-153P to the car as follows:
• The black wire to the vehicle ground.
• The red wire to the permanent 12 V. Always connect the supplied
2 A fuse to this line, close to the source.
CK-200