Nokia Bluetooth Headset BH-607 1 2 4 5 3 6 9 7 8 11 10
12 13 14
ENGLISH DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this BH-607 product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. © 2009 Nokia. All rights reserved. Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation.
ENGLISH Introduction With the Nokia Bluetooth Headset BH-607, you can make and answer calls hands-free with your compatible mobile device. The headset is provided with noise cancellation that helps you handle calls in noisy environments. Read this user guide carefully before using the headset. Also, read the user guide for the device that you connect to the headset. This product may contain small parts. Keep them out of the reach of small children.
ENGLISH without cables. The headset and the other device do not need to be in line of sight, but they should be within 10 metres (33 feet) of each other. Connections may be subject to interference from obstructions, such as walls, or other electronic devices. The headset is compliant with the Bluetooth Specification 2.1 + EDR supporting the Headset Profile 1.1 and Hands-Free Profile 1.5. Check with the manufacturers of other devices to determine their compatibility with this device.
ENGLISH may present a risk of fire, explosion, or other hazard. When you disconnect the power cord of any accessory, grasp and pull the plug, not the cord. 1. Connect the charger to a wall outlet. 2. Connect the charger cable to the charger connector. The red indicator light is displayed during charging. Charging the battery fully may take up to 1 hour. 3. When the battery is fully charged, the green indicator light is displayed. Disconnect the charger from the headset, then from the wall outlet.
ENGLISH headset beeps, and the red indicator light is briefly displayed. If the headset is not connected to a device within about 30 minutes, it switches off automatically. Pair and connect the headset Before using the headset, you must pair and connect it to a compatible device. You can pair the headset with up to eight devices, but you can connect it to only up to two devices at a time. 1. Ensure that your mobile device is switched on and the headset is off. 2.
ENGLISH To manually connect the headset to one or two last used devices, press and hold the answer/end key for about 2 seconds (when no devices are connected), or make the connection in the Bluetooth menu of the desired device. If you have a device connected to the headset and want to connect a second device, make the connection in the Bluetooth menu of the device. You may be able to set your device so that the headset connects to it automatically.
ENGLISH To activate voice dialling (if your mobile device supports this feature with the headset), when no call is in progress, press and hold the answer/ Adjust volume end key for about 2 seconds. Proceed The headset automatically adjusts the as described in the user guide of the volume according to ambient noise. mobile device. Slide the volume key up to increase or To answer or end a call, press the down to decrease the volume. To answer/end key.
ENGLISH Bluetooth Hands-Free Profile 1.5, and call waiting must be activated in the device. Call waiting is a network service and is available when the headset is connected to only one device. To answer a waiting call and end the active call, press the answer/end key. To answer a waiting call and put the active call on hold, press and hold the answer/end key for about 2 seconds. To end the active call and make the call on hold active, press the answer/ end key.
ENGLISH After the settings are cleared, the headset enters pairing mode. To reset the headset if it stops Clear settings or reset functioning, even though it is charged, To clear all the pairing settings from connect the headset to a charger the headset (including settings you while you press and hold the power have defined with the Nokia Accessory key.
ENGLISH If a battery is being used for the first time or if the battery has not been used for a prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it to begin charging the battery. If the battery is completely discharged, it may take several minutes before the charging indicator light is displayed. Unplug the charger from the electrical plug and the device when not in use.
ENGLISH • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely. • Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged. • Do not store the device in high or cold temperature. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics.
ENGLISH electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies in the European Union. Do not dispose of these products as unsorted municipal waste. For more environmental information, see the product Eco-Declarations at www.nokia.com/environment. FCC/Industry Canada notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1.
ENGLISH Changes or modifications not expressly approved by Nokia could void the user's authority to operate the equipment.
