User guide

3 Before Going to the Field
42 Trimble M3 Total Station User Guide
Editing target settings
1. Press [F2] Edit in the Set Target screen. The
Edit Target screen appears.
2. Do one of the following:
– Use the keypad to enter a new value.
– To use values from the stack, press
[F3] Stack.
– To return to the previous screen, press
[ESC].
3. To finish the edit, press
[F4] o.k..
Note – Input the value that is shown on the prism into the
Prism const. field.
Editing data, point number lists or point code lists
1. Press
[7] in the HOT MENU screen to open the
Edit screen.
2. Do one of the following:
– To view and edit data stored in the memory,
press
[F1]. See Viewing and editing data in
internal memory, page 42.
– To edit the point number list, press
[F2]. See
Managing your list of point names, page 44.
– To edit the point code list, press
[F3]. See
Managing your list of point codes, page 45
3. To return to the
HOT MENU screen, press [ESC].
Viewing and editing data in internal memory
This screen reports the current status of the internal
memory:
• Free memory indicates how many more lines
you can record.
• Last address is the address of the last
recorded line in the internal memory.
Do one of the following:
• To open the view data screen, press [F1] Disp.
See Reviewing stored data, page 43.
• To delete data lines, press [F2] Del. See Deleting
data, page 43.
• To input coordinate data, press [F3] Inp.