User guide

Trimble M3 Total Station User Guide 139
Data Formats B
Note – "Rec.mode" can be selected from the following: 1: MEM/1, V24/1; 2: MEM/2, V24/2;
3: 1+2
Stake out x x ST-OUT
x x SO P-LN
RefLine 2D
x x SO D-LN
DifLine 2D
x % PPPPPPPPPPPP Y X Z
depending on stake-out
method
x % PPPPPPPPPPPP Y X
depending on stake-out
method
x % PPPPPPPPPPPP HD Hz Z
depending on stake-out
method
x % PPPPPPPPPPPP HD Hz
depending on stake-out
method
xx % PPPPPPPPPPPP y x
depending on stake-out
method (RefLine 2D)
x % PPPPPPPPPPPP HD
depending on stake-out
method (DivLine 2D)
x PPPPPPPPPPPP SD Hz Vk
k =1, 2, 3, 4, depending on the
V system
x PPPPPPPPPPPP dy dx dz
stake-out difference depending
on meas. method
x PPPPPPPPPPPP dy dx
stake-out difference depending
on meas. method
x PPPPPPPPPPPP dl dc dr
stake-out difference depending
on meas. method
x PPPPPPPPPPPP dz
stake-out difference depending
on meas. method
x PPPPPPPPPPPP dy dx h
stake-out difference depending
on meas. method (RefLine 2D)
x PPPPPPPPPPPP Y X Z
verification
x PPPPPPPPPPPP Y X
verification measurement
x A PPPPPPPPPPPP SD Hz Vk
reference point A (RefLine 2D,
DivLine 2D)
x B PPPPPPPPPPPP SD Hz Vk
reference point B (RefLine 2D)
xA=S
if station is defined as A
(RefLine 2D)
x A=B SD HD h
RefLine 2D A-B
xB=S
if station is defined as B
(RefLine 2D)
Table B.7 Recording data lines (continued)
Mode Rec
1
Mode
2
Content of record
P, C, I
T1 T2 T3
Comments