User guide

B Data Formats
136 Trimble M3 Total Station User Guide
The following units are defined:
C
CAUTION – If the files of the Trimble Elta formats are entered manually, it is important to
remember that when using the data in the instrument, the digits after the comma and
the units need to be adjusted correspondingly.
B8.5 Recording data lines
Tab le B.7 shows how data lines are recorded.
Values Units
Angle measurement gon, DEG, DMS, mil,%
Distances, Coordinates m, ft
Pressure mmHg, hPa, inHg
Temperature Centigrade, Fahrenheit
Standard, PR, etc. No unit defined
Table B.7 Recording data lines
Mode Rec
1
Mode
2
Content of record
P, C, I
T1 T2 T3
Comments
Single meas. x CCCCC PPPPPPPPPPPP Hz Vk
HA VA mode, k=1, 2, 3, 4
depending on V system
x CCCCC PPPPPPPPPPPP HD Hz h/Z
horizontal distance mode
x CCCCC PPPPPPPPPPPP SD Hz Vk
slope distance mode, k=1, 2, 3, 4
depending on V system
x CCCCC PPPPPPPPPPPP y x h/Z
coordinates mode, sequence y,x
x CCCCC PPPPPPPPPPPP x y h/Z
coordinates mode, sequence x,y
x CCCCC PPPPPPPPPPPP n e h/Z
coordinates mode, sequence n,e
x CCCCC PPPPPPPPPPPP e n h/Z
coordinates mode, sequence e,n
Adjustment
c/i
x x ADJUST Vk Vk i
k=1, 2, 3, 4 depending on V
system
x x ADJUST Hz Hz c
x x ADJUST SK SZ
Adjust comp. x x ADJUST SK SZ
Input values x x INPUT th ih
x x INPUT T_ P PC
x x INPUT m
x x S PPPPPPPPPPPP Z
Z ... station height
Compensator x x COM-ON
Compensator activated
x x COM-OFF
Compensator deactivated