User guide

Trimble M3 Total Station User Guide 111
Data Transfer 9
9.5 Specifications
C
CAUTION – Use only the male connectors specified here. Using other connectors will
damage the instrument.
Input voltage: 7.2 V to 11 V DC
System: RS-232C
Signal level: ±9 V standard
Maximum baud rate: 38400 bps asynchronous
Compatible male connector: Hirose HR10A-7P-6P or HR10-7P-6P
9.6 XON/XOFF Control
The XON/XOFF protocol is a very simple, but efficient data transmission protocol
which is used by the Trimble M3 total station as well as terminal applications such as
Hyperterminal and Xtalk.
Make sure that your PC application is configured for XON/XOFF operation when
communicating with the Trimble M3 total station.
9.7 Downloading internal memory to an office computer
To use data transfer functions, press [MENU] [7] Data
Transfer
.
• To transfer recorded data in the instrument to
the office computer, press
[1] MEM-Periph. See
Transferring recorded data to the office
computer, page 112.
• To upload data created on an office computer to
the instrument, press
[2] Periph-MEM. See
Uploading data from an office computer to the
internal memory, page 113.
Transmitter
Receiver