Operating instructions

Preparing to Print
34
2
Note
❒ If [Found New Hardware Wizard] ap-
pears every time the computer is
started or the cable is connected
with Windows 2000 or Windows
XP when the printer function that
uses SCSI print is not installed, dis-
able the device. See p.35 “Dis-
abling the Device” for more
information.
❒ If you send data from your com-
puter when data is being received
from another client computer,
your data will be printed after
completing the print job for the
other client computer.
❒ When the machine is connected to
the computer properly via the 1394
interface, the appearance of the
icon in the printer window chang-
es.
Windows 2000
Important
❒ In Windows 2000, the optional
IEEE 1394 Interface Board can only
be used with Service Pack 1 or lat-
er. If the Service Pack is not in-
stalled, the connectable number of
devices in an IEEE 1394 bus is only
one, and the client cannot access
the IEEE 1394 Interface Board
without using an account that has
Administrator permission.
A
AA
A
Connect the machine and the
computer using the IEEE 1394 in-
terface cable.
The [Found New Hardware Wizard] di-
alog box appears.
B
BB
B
Click [Next].
The message [This wizard will com-
plete the installation for this Device:
Unknown] appears.
C
CC
C
Select [Optional search locations:],
and then click [Next].
D
DD
D
When the [Locate Driver Files] mes-
sage appears, select the [Optional
search locations.] check box and the
[Specify a location] checkbox, and
then click [Next].
E
EE
E
Hold down the left {
{{
{SHIFT}
}}
} key on
the keyboard and insert the CD-
ROM into the CD-ROM drive.
Keep the left {
{{
{SHIFT}
}}
} key held
down until the computer has fin-
ished accessing the CD-ROM.
If the Auto Run program starts,
click [Cancel], and then [Exit].
F
FF
F
Click [Browse].
G
GG
G
Select the printer driver you want
to install. Each printer driver is
stored in the following folders:
• PCL 6: \DRIVERS\PCL6\
WIN2K_XP\(Language)\DISK1
• PCL 5e: \DRIVERS\PCL5E\
WIN2K_XP\(Language)\DISK1
• RPCS™: \DRIVERS\RPCS\
WIN2K_XP\(Language)\DISK1
• PostScript 3: \DRIVERS\PS\
WIN2K_XP\(Language)\DISK1
H
HH
H
Click [Open].
I
II
I
Click [OK].
A printer model selection dialog
box appears.