User manual

Vehicles
Radio signals may affect improperly installed or inadequately shielded electronic systems in motor vehicles such as
electronic fuel injection, electronic antilock braking, electronic speed control, and air bag systems. For more information,
check with the manufacturer of your vehicle or its equipment.
Only qualified personnel should install the device in a vehicle. Faulty installation or service may be dangerous and may
invalidate your warranty. Check regularly that all wireless device equipment in your vehicle is mounted and operating
properly. Do not store or carry flammable liquids, gases, or explosive materials in the same compartment as the device, its
parts, or accessories. Remember that air bags inflate with great force. Do not place your device or accessories in the air
bag deployment area.
Potentially explosive environments
Switch off your device in any area with a potentially explosive atmosphere, for example near gas pumps at gas stations.
Sparks in such areas could cause an explosion or fire resulting in bodily injury or death. Observe restrictions in gas stations,
storage, and distribution areas; chemical plants; or where blasting operations are in progress. Areas with a potentially
explosive atmosphere are often, but not always, clearly marked. They include areas where you would be advised to turn off
your vehicle engine, below deck on boats, chemical transfer or storage facilities and where the air contains chemicals or
particles such as grain, dust, or metal powders. You should check with the manufacturers of vehicles using liquefied
petroleum gas (such as propane or butane) to determine if this device can be safely used in their vicinity.
Certification information (SAR)
This cellular device meets guidelines for exposure to radio waves.
Your cellular device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves
recommended by international guidelines. These guidelines were developed by the independent scientific organization
ICNIRP and include safety margins designed to assure the protection of all persons, regardless of age and health.
The exposure guidelines for cellular devices employ a unit of measurement known as the Specific Absorption Rate or SAR.
The SAR limit stated in the ICNIRP guidelines is 2.0 watts/kilogram (W/kg) averaged over 10 grams of tissue. Tests for SAR
are conducted using standard operating positions with the device transmitting at its highest certified power level in all tested
frequency bands. The actual SAR level of an operating device can be below the maximum value because the device is designed
to use only the power required to reach the network. That amount changes depending on a number of factors such as how
close you are to a network base station.
The highest SAR value under the ICNIRP guidelines for use of the device at the ear is 1.23 W/kg .
Use of device accessories may result in different SAR values. SAR values may vary depending on national reporting and
testing requirements and the network band. Additional SAR information may be provided under product information at
www.nokia.com.
Your cellular phone is also designed to meet the requirements for exposure to radio waves established by the Federal
Communications Commission (USA) and Industry Canada. These requirements set a SAR limit of 1.6 W/kg averaged over
one gram of tissue. The highest SAR value reported under this standard during product certification for use at the ear is
1.21 W/kg and when properly worn on the body is 1.46 W/kg .
Copyright and other notices
DECLARATION OF CONFORMITY
130 Copyright and other notices