User manual

● Connection name — Enter a descriptive name for
the connection.
● Data bearer — Select the data connection type.
Depending on the data connection you select, only
certain setting fields are available. Fill in all fields
marked with Must be defined or with a red asterisk.
Other fields can be left empty, unless you have been
instructed otherwise by your service provider.
To be able to use a data connection, your service
provider must support this feature, and if necessary,
activate it for your SIM card.
Packet data access points
Press , and select Tools > Settings >
Connection > Access points > Options > Edit or
New access point.
Follow the instructions from your service provider.
● Access point name — You obtain the access point
name from your service provider.
● User name — The user name may be needed to
make a data connection, and is usually provided by
the service provider.
● Prompt password — If you must enter the
password every time you log in to a server, or if you
do not want to save your password in the device,
select Yes.
● Password — A password may be needed to make
a data connection and is usually provided by the
service provider.
● Authentication — Select Secure to always send
your password encrypted or Normal to send your
password encrypted when possible.
● Homepage — Depending on the access point you
are setting up, enter the web address or the address
of the multimedia messaging centre.
Select Options > Advanced settings to change the
following settings:
● Network type — Select the internet protocol type
to transfer data to and from your device. The other
settings depend on the selected network type.
● Phone IP address (for IPV4 only) — Enter the IP
address of your device.
● DNS address — Enter the IP addresses of the
primary and secondary DNS servers, if required by
your service provider. Contact your internet service
provider to obtain these addresses.
● Proxy server address — Enter the address of the
proxy server.
● Proxy port number — Enter the port number of
the proxy server.
WLAN internet access points
Press , and select Tools > Settings >
Connection > Access points > Options > Edit or
New access point.
Follow the instructions from the WLAN service
provider.
100
Settings