User manual

Tools
96
Network
Operator selection—Select Automatic to set the device
to search for and select one of the available networks,
or Manual to manually select the network from a list
of networks. If the connection to the manually selected
network is lost, the device sounds an error tone and asks
you to reselect a network. The selected network must have
a roaming agreement with your home network, that is,
the operator whose SIM card is in your device.
Glossary: A roaming agreement is an agreement
between two or more network service providers
to enable the users of one service provider to use
the services of other service providers.
Cell info display—Select On to set the device to indicate
when it is used in a cellular network based on microcellular
network (MCN) technology and to activate cell info reception.
Enhancement
In the standby mode, indicates a compatible headset
is connected, and that the headset is unavailable, or a
Bluetooth connection to a headset is lost. indicates a
compatible loopset is connected and that a compatible
TTY is connected.
Select Headset, Loopset, TTY, Bluetooth handsfree,
or Car kit and from the following:
Default profile—Set the profile that you want activated
each time you connect a certain compatible enhancement
to your device. See "Profiles—set tones," p. 84.
Automatic answer—Set if you want the device to answer
an incoming call automatically after 5 seconds. If the ringing
type is set to Beep once or Silent, automatic answer
is disabled. Automatic answer is not available for TTY.
Lights—Set whether lights remain on, or are switched
off after the time-out. This setting is not available for
all enhancements.
If you are using a TTY, you must activate it on your device.
Press , and select Tools > Settings > Enhancement >
TTY > Use TTY > Yes.
Voice commands
You can use voice commands to control your device. For
more information about the enhanced voice commands
supported by your device, see "Voice dialing," p. 64.
To activate enhanced voice commands for starting
applications and profiles, you must open the Voice cm.
application and its Profiles folder. Press , and select
Tools > Voice cm. > Profiles; the device creates voice tags