User manual

• Wireless LAN — Set the device to display an indicator
when a wireless LAN (WLAN) is available, and define how
often the device searches for networks.
• Video sharing — Enable video sharing, select the SIP
profile for video sharing, and define the video saving
settings.
• SIP settings — View or create session initiation protocol
(SIP) profiles.
• XDM settings — Create an XDM profile. The XDM profile is
required for many communications applications, for
example, presence.
• Presence — Edit the settings for presence (network
service). To register for the service, contact your service
provider.
• Remote drives — Connect the device to a remote drive.
• Configurations — View and delete trusted servers from
which your device may receive configuration settings.
• APN control — Restrict packet data connections.
Access points
Create a new access point
Select Menu > Control panel > Settings and
Connection > Destinations.
You may receive access point settings in a message from a
service provider. Some or all access points may be preset for
your device by your service provider, and you may not be able
to change, create, edit, or remove them.
When you select one of the access point groups ( , , ,
, ), you can see the access point types:
indicates a protected access point
indicates a packet data access point
indicates a wireless LAN (WLAN) access point
Tip: You can create internet access points in a WLAN
with the WLAN wizard.
To create a new access point, select
Access point. The
device asks you to check for available connections. After the
search, connections that are already available are displayed
and can be shared by a new access point. If you skip this step,
you are asked to select a connection method and to define
the settings needed.
To edit the settings of an access point, select one of the access
point groups, scroll to an access point, and select Edit. Use
the instructions provided by your service provider to edit the
following:
• Connection name — Enter a name for the connection.
• Data bearer — Select the data connection type.
Depending on the data connection you select, only certain
setting fields are available. Fill in all fields marked with Must
be defined or with a red *. Other fields can be left empty,
unless your service provider has instructed otherwise.
To use a data connection, your service provider must support
this feature, and if necessary, activate it for your SIM card.
Settings
© 2008 Nokia. All rights reserved.152