User manual
Table Of Contents
- Nokia E70 User Guide
- Contents
- For your safety
- Get started
- Your device
- Make calls
- Contacts
- Messages
- Connectivity
- Internet access points
- Set up an Internet access point for data calls
- Advanced Internet access point settings for data calls
- Set up an Internet access point for packet data (GPRS)
- Advanced Internet access point settings for packet data (GPRS)
- Set up an Internet access point for wireless LAN
- Advanced Internet access point settings for wireless LAN
- Cable connection
- IP passthrough
- Bluetooth
- SIM access profile
- Infrared
- Data connections
- Connection manager
- Modem
- Mobile VPN
- Email data roaming
- Internet access points
- Web
- Media applications
- Camera
- Office applications
- Settings
- Organiser
- Tools
- Device manager
- Personalization
- Nokia original enhancements
- Shortcuts
- Care and maintenance
- Additional safety information
- Technical information
- Index
5. Insert the locking catches of the back cover into the corresponding slots (1), and slide the cover in the direction of the arrow
(2).
Insert a memory card
If you have a memory card, follow the instructions to insert it.
See "Memory," p. 15.
1. Remove the battery cover.
2. Insert the memory card fully into the memory card slot. Ensure that the beveled corner of the memory card is pointing
towards the device and the contact area is facing down.
3. Replace the battery cover.
4. To remove the memory card, press the power key, and select Remove mem. card. Remove the battery cover, and push the
memory card into the device to activate the release mechanism. Then, gently pull the card out of your device.
Important: Do not remove the memory card in the middle of an operation when the card is being accessed.
Removing the card in the middle of an operation may damage the memory card as well as the device, and data
stored on the card may be corrupted.
Charge the battery
1. Connect the charger to a wall outlet.
2. Connect the power cord to the bottom of the device. The battery indicator bar starts scrolling on the display. If the battery
is completely discharged, it may take a few minutes before the charging indicator is shown. The device can be used while
charging.
3. When the battery is fully charged, the bar stops scrolling. Disconnect the charger from the device, then from the outlet.
When the battery charge level is too low for operation, the device switches itself off.
Switch on your device
1. To switch the device on, press the power key.
2. If the device asks for a PIN code, lock code, or security code, enter the code, and select OK.
3. To switch the device off, press the power key.
Tip: When you switch the device on, it may recognize the SIM card provider and configure the correct text message,
multimedia message, and GPRS settings automatically. If not, contact your service provider for the correct settings, or
use the Sett. wizard application.
The device can be used without the network dependent phone functions when a SIM card is not inserted, or when the Offline
profile is selected.
G e t s t a r t e d
Copyright © 2006 Nokia. All Rights Reserved. 9