User manual

Data call settings
Select Menu > Tools > Settings > Connection > Data call.
To set the time-out period after which data calls automatically end if no data has been transferred, select Online time, and press
the joystick. Select User defined to enter the time yourself or Unlimited to keep the connection active until you select Options >
Disconnect.
VPN
VPN access points
To manage VPN access points, select VPN > VPN access points > Options and from the following options:
• Edit — Edit the selected access point. If the access point is in use or its settings are protected, you cannot edit it.
• New access point — Create a new VPN access point.
• Delete — Delete the selected access point.
VPN access point settings
Contact your service provider for the correct access point settings.
To edit VPN access point settings, select the access point and Options.
Select from the following options:
• Connection name — Enter a name for the VPN connection. The maximum length of the name is 30 characters.
• VPN policy — Select a VPN policy to be used with this access point.
• Internet access pt. — Select the Internet access point to be used with this VPN access point.
• Proxy serv. address — Enter the proxy server address of this VPN access point.
• Proxy port number — Enter the number of the proxy port.
Wireless LAN
Select Menu > Tools > Settings > Connection > Wireless LAN.
To have an indicator displayed when there is a wireless LAN available in your current location, select Show availability > Yes.
To select the time interval for your device to scan for available wireless LANs and update the indicator, select Scan for
networks. This setting is not visible unless you select Show availability > Yes.
Advanced WLAN settings
Select Menu > Tools > Settings > Connection > Wireless LAN > Options > Advanced settings. The wireless LAN advanced settings
are normally defined automatically, and changing them is not recommended.
To edit the settings manually, select Automatic config. > Disabled, and define the following settings:
• Long retry limit — Enter the maximum number of transmission attempts if the device does not receive a receiving
acknowledgement signal from the network.
• Short retry limit — Enter the maximum number of transmission attempts if the device does not receive a clear-to-send signal
from the network.
• RTS threshold — Select the data packet size at which the wireless LAN access point device issues a request to send before
sending the packet.
• TX power level — Select the power level of your device when sending data.
• Radio measurements — Enable or disable the radio measurements.
To restore all settings to their original values, select Options > Restore defaults.
Security settings for wireless LAN access points
WEP security settings
Select Menu > Tools > Settings > Connection > Access points. Select Options > New access point; or select an access point and
Options > Edit.
In the access point settings, select WLAN security mode > WEP.
Wired equivalent privacy (WEP) encryption method encrypts data before it is transmitted. Access to the network is denied to
users who do not have the required WEP keys. When WEP security mode is in use, if your device receives a data packet not
encrypted with the WEP keys, the data is discarded.
In an Ad-hoc network, all devices must use the same WEP key.
Select from the following settings:
• WEP key in use — Select the desired WEP key.
• Authentication type — Select Open or Shared.
• WEP key settings — Edit the settings for the WEP key.
S e t t i n g s
Copyright © 2006 Nokia. All Rights Reserved. 72