User manual

Use access point — Select After confirmation if you want the device to ask for
confirmation before the connection using this access point is created, or
Automatically if you want the device to connect to the destination using this access
point automatically.
Select Options > Advanced settings and from the following:
Network type — Select the internet protocol type to transfer data to and from
your device. The other settings depend on the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address of your device.
DNS addresses — Enter the IP addresses of the primary and secondary DNS servers,
if required by your service provider. To obtain these addresses, contact your internet
service provider.
Proxy server address — Enter the address of the proxy server.
Proxy port number — Enter the port number of the proxy server.
Wi-Fi internet access points
Select . Menu > Ctrl. panel > Settings and Connection > Destinations > Access
point, and follow the instructions on the display. Or, open one of the access point
groups, select an access point marked with
, and select Options > Edit.
Use the instructions provided by your service provider to edit the following:
Connection name — Define a name for the connection.
Data bearer — You might not be able to edit the data bearer once defined. Define
a new access point if needed.
WLAN network name — Select Enter manually or Search for networks. If you
select an existing network, WLAN network mode and WLAN security mode are
determined by the settings of its access point device.
Network status — Define whether the network name is displayed.
Settings 187