User manual

The remote configuration connection is usually started by the server when the
device settings need to be updated.
To create a new server profile, select Options > Server profiles > Options > New
server profile.
You may receive these settings from your service provider in a configuration
message. If not, define the following:
Server name — Enter a name for the configuration server.
Server ID — Enter the unique ID to identify the configuration server.
Server password — Enter a password to identify your device to the server.
Access point — Select the access point to use for the connection, or create a new
access point. You can also choose to be asked for the access point every time you
start a connection. This setting is available only if you have selected Internet as the
bearer type.
Host address — Enter the web address of the configuration server.
Port — Enter the port number of the server.
User name and Password — Enter your user ID and password for the configuration
server.
Allow configuration — Select Yes to allow the server to initiate a configuration
session.
Auto-accept all requests — Select Yes if you do not want the server to ask for
your confirmation when it initiates a configuration session.
Network authentication — Select whether to use http authentication.
Network user name and Network password — Enter your user ID and password
for the http authentication. This setting is available only if you have selected
Network authentication to be used.
166 Security and data management