User`s manual

MICROSENS 8 Port Gigabit Ethernet Switch User’s Manual

Mode:

Set the speed and duplex of the port. In speed, if the media is 1Gbps fiber, it is always

1000Mbps and the duplex is full only. If the media is TP, the Speed/Duplex is comprised

of the combination of speed mode, 10/100/1000Mbps, and duplex mode, full duplex

and half duplex. The following table summarized the function the media supports.

Media type NWay Speed Duplex

1000M TP ON/OFF 10/100/1000M Full for all, Half for 10/100

1000M Fiber ON/OFF 1000M Full

In Auto-negotiation mode, no default value. In Forced mode, default value depends

on your setting.

Flow Control:

There are two modes to choose in flow control, including Enable and Disable. If flow

control is set Enable, both parties can send PAUSE frame to the transmitting device(s)

if the receiving port is too busy to handle. When it is set Disable, there will be no

flow control in the port. It drops the packet if too much to handle.

Default: Enable.

Wait State:

For more details about this parameter please refer to section 3-2-1.

Default: Disable.