User`s manual

Batch/Battery
Save
Settings
Default
to USB
Default
to PS/2
Clear
All Data
Clear
XML
Rules
4-18 MS-Q Imager User’s Manual
Transferring and Deleting Data
The MS-Q Imager has three different commands that can transfer data or delete data in
memory.
All data in memory is sent every time the Transfer All Data
symbol is read.
Every time the Transfer New Data symbol is read, only the
data in memory that hasn’t been sent will be transferred.
Note: This command is not applicable in Log Only Mode. If
you are in Log Only Mode, use Transfer All Data.
Reading the Delete Data symbol will erase all data in the
imager’s non-volatile memory.
Auto-Transfer Buffer Memory
By default, when the MS-Q re-connects to the host, it will automatically transfer any data in
memory. If the application on your host computer is not ready, the imager will send the
data anyway, and the data could be lost. If you do not wish for the imager to send data
immediately upon connection, read the Disable Auto-Transfer Buffer Memory symbol.
Transfer All
Data
Transfer New
Data
Delete Data
Enable Auto-Transfer
Buffer Memory (Default)
Disable Auto-Transfer
Buffer Memory