User`s manual

2-12 MS-Q Imager User’s Manual
Menu Toolbar
Connect
Connection Wizard
When you choose to connect to the imager via the Connection Wizard, you will first need
to select the correct protocol (see Select Protocol and Connect to Imager in Chapter 1,
Quick Start.)
When you have successfully connected to the imager you will see one of the two following
displays in the status bar at the lower right of the screen:
Settings / Options
Settings allows you to set baud rate, parity, stop bits, data bits and communications port
for the RS-232 interface before connecting.
Options allows you to auto-connect to the imager (RS-232), follow standard connection
procedure (RS-232 and USB), and disconnect the imager from ESP (RS-232 and USB).
RS-232:
USB: