User`s manual

Quick Start
MS-Q Imager User’s Manual 1-13
Select Protocol and Connect to Imager
RS-232
• In the Select Protocol dialog box, select the communications protocol you are using
and click Next.
•Print the RS-232 Connect Mode symbol and read it with the imager to ensure that you
are in the correct communications mode. Keep the printed symbol in a convenient place
for future use.
• Click Next when you are finished.
•The Com Port dialog will then appear. Select which communications port you are using.
If you don’t see your communications port listed on the dropdown menu, select Other.
• Click Connect.
• When you are connected successfully, the CONNECTED message will appear in a
green box in the status bar at the bottom right of the screen.
If the connection attempt fails, enable a different communications port, check your port
connections, and try again. You can also check the Force Connect box and then click
the Connect button.
You are now ready to configure your imager using ESP. Subsequent sections provide
more detailed information about ESP’s configuration options.