User`s manual

RS-232 Interface
1-8 MS-Q Imager User’s Manual
Save
Settings
Default
to USB
Default
to PS/2
Clear
All Data
Clear
XML
Rules
RS-232 Interface
Note: Unlike USB and PS/2, the RS-232 interface does not draw its power from the host computer.
RS-232 Configuration
Installation Steps for RS-232
1. Power-off the host computer.
2. Connect the 8-pin mini-DIN on the
cable (2) to the MS-Q (1).
3. Connect the 9-pin D-sub connector to
the host computer’s serial port.
4. Connect the cable to the power supply.
5. Plug in the power supply (3) and
power-on the host computer.
6. Start up a terminal program (such as
ESP ’s Terminal view or HyperTerminal)
and set to 57.6K baud, 8 data bits,
none parity, 2 stop bits, and none
hardware.
7. Read the RS-232 Default Settings
Mode symbol below.
8. Read the Save Settings symbol at the bottom of this page.
You are now ready to send data to the host.
Item Description Part Number
1 MS-Q Imager
Quadrus: FIS-6100-XXXXG
Basic: FIS-6150-XXXXG
Note: For the RS-232 option, order any MS-Q FIS
plus the RS-232 kit listed below.
RS-232 Kit includes:
98-000074-04 (U.S.) -05 (Europe) -06 (UK)
2 RS-232 Cable
3 Power Supply
RS-232 Configuration
RS-232 Default Settings Mode