User`s manual

USB Interface

1-6 MS-Q Imager User’s Manual

Save

Settings

Default

to USB

Default

to PS/2

Clear

All Data

Clear

XML

Rules

USB Interface

Note: The USB interface draws its power from the host computer.

USB Configuration

Installation Steps for USB

1. Connect the USB cable (

) to the MS-Q (

2. Connect the USB cable (2) to the host.

You DO NOT need to power off your

host computer.

3. Open any program in your host computer

that can receive keyboard text.

4. Read the USB Keyboard Mode symbol

below:

5. Read the Save Settings symbol at the

bottom of this page.

You are now ready to send data to the host.

Note: If you attempt to connect to the host via USB and you have a battery installed, the

host will fail to recognize the imager for approximately 60 seconds. If you connect with a

battery blank installed, or if you install the battery after plugging in, no delay occurs.

Item Description Part Number

1 MS-Q Imager

Rev 5 Hardware Rev 6 Hardware

Quadrus: FIS-6100-0030G,

-0035G, -0046G

Basic: FIS-6150-0020G

Quadrus: FIS-6100-0047G,

-0051G, -0053G

Basic: FIS-6150-0028G

2 USB Cable Included

USB Configuration

USB Keyboard Mode