User`s manual

Quick Start
MS-Q Imager User’s Manual 1-3
Assemble the Imager
To assemble the MS-Q Imager with Cabled Handle (H2):
1. Insert the flexible connector at the back of the H2 Handle into the MS-Q’s 8-pin DIN
connector.
2. Snap the imager onto the H2 Handle over the battery blank. Be sure that the underside
of the imager is latched at the front of the handle.
3.
Secure the flexible connector at the back of the H2 Handle with the two screws provided.
4. Secure the underside of the imager to the H2 Handle with the two screws provided.
5. Attach the cable to the bottom of the handle. Secure the cable clamp with the two
screws provided.
Flexible
Connector
Flexible
Connector
Latch
Screws
Screws
Insert screws in the through-holes
at the base of the cable clamp.