User`s manual

Chapter 3 Serial Configuration
3-8
MS-3000 Single Head Decoder User’s Manual
3–Serial Config.
LRC
Example: To enable LRC, enter <Kc1>.
Host Response Timeout
Example: To change Response Timeout to 30 ms, enter <KA30>.
Intercharacter Delay
Example: To change Intercharacter Delay to 30 ms, enter <KB30>.
Host Port
Note: Changes made in the decoder’s communications parameters such as
baud rate, parity, stop bits, LRC, etc., must be matched in the other device(s) or
communications will be lost. If this occurs, default the decoder as described in
Appendix C — “Defaulting the Decoder.”
Example: To change the baud rate to 2400, enter <Ka2>.
To change Data Bits to Eight without changing any other fields, enter either:
<Ka,,,1> or <Ka4,1,0,1>.
Format: <Kcstatus>
status:
0 = Disabled 1 = Enabled
Format: <KAtimeout setting>
timeout setting:
Any number from 0 to 65,000 (a zero creates an indefinite wait).
Default is 12 (ms).
Format: <KBtime interval>
time interval (in milliseconds between characters):
Any number from 0 to 255. Default is 0.
Format: <Kabaud rate,parity,stop bits,data bits>
baud rate:
0 = 600 3 = 4800
1 = 1200 4 = 9600
2 = 2400 5 = 19.2K 6 = 38.4K
parity:
0 = None
1 = Even
2 = Odd
stop bits:
0 = One 1 = Two
data bits:
0 = Seven 1 = Eight