User`s manual

MS-3000 Single Head Decoder User’s Manual
3-5
3–Serial Config.
access. If this should occur, try gaining access to the decoder by use of a pro-
file card
1
or by entering a <D> command from an auxiliary terminal via the
auxiliary RS-232 port. If neither of these methods is available, try defaulting
the decoder. See Appendix C, “Defaulting the Decoder,” on page A-4.
Trigger Filter Timing Value
Returns the current trigger filter timing value in milliseconds.
Allows you to set trigger filter timing. Divide the desired number of millisec-
onds by 10 and enter the quotient.
1. See mode 0 in Chapter 4, “Profile Card Configuration.”
Format: <KF?>
Format: <KFone tenth trigger filter timing value>