User`s manual

Chapter 2 Menu Configuration
2-30
MS-3000 Single Head Decoder User’s Manual
2–Menu Config.
Beeper Speed
Default: Fast
Options: Fast, Slow
Beeper Speed allows you to set the beeper to accommodate your appli-
cation. The beeper takes approximately 80 ms to sound when Slow is
enabled. If your application speed is faster than 80 ms (approximately),
enable Fast.
Full Screens
Default: Enabled
Options: Enabled, Disabled
Allows you to display either the full menu screen or just the command line.
When Full Screens is disabled, only the command line will be displayed.
Relay Driver
Default: Mismatch Or Noread
Options: Mismatch Or Noread, Good Match, Mismatch, Noread
Note:
All options (except Noread) require that you enable Match Code (page
2-19) and download a master label into memory.
Allows you to determine the conditions under which a Relay Driver pulse
of 5V is output. To see your options for enabling Match Code and down-
loading a master label into memory, see figure 2-4, “Match Code Logic
Diagram,” on page 2-20.
Selecting: Has this effect:
Mismatch
or Noread
Sends a pulse to pin 2 of the trigger connector when
a label’s data does not match that of the master label,
or the label is not decoded before the end of the read
cycle.
Good Match Sends a pulse to pin 2 of the trigger connector when
a label’s data matches that of the master label.
Mismatch Sends a pulse
to pin 2 of the trigger connector
when
a label’s
data does not match that of the
master label.
Noread Sends a pulse
to pin 2 of the trigger connector
when no data is decoded before the end of the
read cycle.