User`s manual

A-52
Prompts and Messages
List of Prompts and Messages
Table number entry required
This message displays if you are programmed to handle checks
by table number, and you try to post detail to the check without
entering a table number. Enter a table number to continue.
Tare too large
This message displays if you enter a weight for a weighed menu
item that is smaller than the tare weight (the weight of the
empty packaging). Press [Clear] to continue. Enter the
combined weight of the weighed menu item and its package.
Tender not found
Tender preset not found
This message displays for either of these reasons:
❏ You entered a tender/media NLU number that does not
exist.
❏ You pressed a [Credit Card Recall] key for a credit card
number that has not yet been defined with a [Credit Card]
or [Credit Card Lookup] key.
Press [Clear]. Verify the tender NLU number or credit card
number and re-enter it.
Tender required
A revenue center may be programmed to require tendering in
full after a partial tender. This message displays if you post a
partial tender, and then try to do anything else but close this
check. Press [Clear] to continue. You may void the partial
tender that was just entered, or you may fully tender the check.
Tender/media group
This message follows the prompt “Authorization is required
for:” It displays if you try to use a [Discount] key for which you
are not privileged. Enter an authorized employee’s ID to
continue, or press [Clear] to cancel.
This menu item is sold out
This message displays when you order a limited availability
menu item and the counter for this item has decremented to
zero, meaning there are none left. Press [Clear] to continue.
The number available for this menu item may be changed by an
authorized employee using Manager Procedures.