User`s manual

A-32
Prompts and Messages
List of Prompts and Messages
Last item void
This message follows the prompt “Authorization is required
for:” It displays if you try to perform a last item void and are not
privileged to do so. Enter an authorized employee’s ID to
continue, or press [Clear] to cancel.
Last item void not allowed
This message displays for either of these reasons:
❏ You partially tender a guest check to a PMS then try to void
it using last item void. On completing the partial tender, the
charge is automatically posted to the PMS computer, so a
last item void is not allowed. To void an incorrect partial
tender posted to a PMS, void it as if it had been entered in a
previous service round.
❏ You print a memo check and then try to use last item void to
remove a transaction detail item.
❏ You perform a credit authorization or credit final operation
and then try to void it using last item void.
Press [Clear] to continue.
Line in use by other application
This message displays during any type of credit authorization
when the modem is being used by another application (such as a
fax driver). Wait a few seconds, then try again; or terminate the
application using the modem, then try again.
Lost host connection
This message displays during any type of credit authorization if
the host detect signal is low anytime the CA/EDC driver is
waiting for data. It usually means the telephone line was
dropped. Try the authorization again. If the problem persists, do
the following:
❏ Connect a telephone to the phone jack used by the modem
and dial the same number. Verify the connection is not noisy.
❏ Verify that the correct modem setup string has been
configured for this modem. Refer to POS Configurator online
help for more information.
❏ Contact your support representative.