User`s manual

3700 User’s A-27
Prompts and Messages
List of Prompts and Messages
❏ You try to post a subtotal discount while seat filtering is
active, and your system has been programmed to prevent
this. Press [Clear] to continue.
Guest Check ID
This message follows the prompt “Authorization is required
for:” It displays when you try to enter or change a guest check
ID and are not privileged to do so. Enter an authorized
employee’s ID to continue, or press [Clear] to cancel.
Guest check ID entry required
This message displays when you pick up a guest check that does
not have a required guest check ID. Enter a guest check ID to
continue.
Guest count exceeds maximum allowed
This message displays if, when adding two checks, the
combined guest count exceeds the maximum allowed (999).
Change the guest count on one of the checks and continue.
Host disconnected
This message displays during any type of credit authorization if
the credit card processor receives an erroneous request from the
CA/EDC driver and disconnects by issuing an End of
Transmission (EOT) byte. Try the authorization again. If the
problem persists, do the following:
❏ Connect a telephone to the phone jack used by the modem
and dial the same number. Verify the connection is not noisy.
❏ Verify that the correct modem setup string has been
configured for this modem. Refer to POS Configurator online
help for more information.
❏ Contact your support representative.
ID cannot be added to check
This message indicates a problem with the database. Contact
your support representative.
Incorrect condiment type
This message displays when you try to add a condiment to a
menu item and the menu item does not require or allow this
particular condiment. Press [Clear] to continue.