User`s manual

A-20
Prompts and Messages
List of Prompts and Messages
Discount group
This message follows the prompt “Authorization is required
for:” It displays if you try to use a [Discount] key you’re not
privileged to use. Enter an authorized employee’s ID to
continue, or press [Clear] to cancel.
Discount not found
This message displays under one of the following conditions:
❏ You entered a discount NLU number that does not exist.
❏ You pressed a [Discount] key that is not active on the
currently assigned menu level(s).
Press [Clear] and verify the discount NLU number or menu
level.
Dollar amount too large
This message displays during any type of credit authorization if
the amount of the authorization request exceeds the limit
established by the credit card company. For example, a single
Discover card authorization cannot exceed $99.999.99. Verify
the amount due. If necessary, split the amount between more
than one guest check so you can tender each check separately.
Driver failed to load
This message displays during any type of credit authorization
or credit card tender if the credit card server could not load the
correct driver. Press [Clear] to cancel and do a manual
authorization instead. Report the problem to your support
representative immediately.
Driver not programmed
This message displays during any type of credit authorization
or credit card tender if the configuration for the CA/EDC driver
is not present in the credit card server’s registry. Press [Clear]
to cancel and do a manual authorization instead. Report the
problem to your support representative immediately.
Edit closed check
This message follows the prompt “Authorization is required
for:” It displays when you try to edit a closed check with the
[Edit Closed Check] key and are not privileged to do so. Enter
an authorized employee’s ID to continue, or press [Clear] to
cancel.