User`s manual

A-16
Prompts and Messages
List of Prompts and Messages
❏ You press a [Discount], [Service Charge], or [Tender/Media]
key outside of a transaction.
❏ You press a [Menu Item] key outside of a transaction and
you are not privileged to begin a fast transaction or the
revenue center is programmed to prevent fast transactions.
Press [Clear] to continue and begin or pick up a guest check.
Check total read failed
Programming error. Contact your support representative.
Check transfer not required
This message displays if you try to transfer a check you already
own to yourself. Press [Clear] to continue.
Clock in?
This prompt displays if the UWS is programmed to confirm
clock in. Press [Enter] to confirm or [Clear] to cancel
Clock in, <job name>
This message follows the prompt “Authorization is required
for:” It displays if you try to clock in under a job you’re not
privileged for. Enter an authorized employee’s ID to continue, or
press [Clear] to cancel.
Clock in/out, enter your ID number
This prompt displays when you press the [Clock In/Out] key
without first typing your employee number or ID. Press [Clear],
then enter the correct number.
Clock out with open checks
This message follows the prompt “Authorization is required
for:” It displays if these three conditions are true:
❏ Checks are still open on the system for which you are listed
as the check employee.
❏ You attempt to clock out.
❏ You are not privileged to clock out with open checks.
A privileged employee’s ID must be entered to clock out; or you
can press [Clear], close your open checks and then clock out.