User's Manual

21
Camera Kit Assembly & Installaon
Next we will cover how the cameras and camera components are assembled and installed. Some installers nd it
easier to do the assembly process on mulple cameras at the same me, and bring the cameras to the pole “ready
to bolt on”. Others prefer to assemble the parts at each locaon. Regardless the camera / solar panel / antenna
assembly process should be done on the ground, prior to actually mounng any of the equipment. As much as
possible this guide is moving in chronological order, so we will rst cover the assembly of the parts, and then
address the mounng / installaon process.
System Assembly
Camera Assembly
The camera itself only needs to have the camera swivel
bracket aached to it.
1. Remove the camera bracket from the packaging, and
remove the pivong mount from the main bracket,
by removing the single screw that holds it in place.
Replace the screw back into the pivong bracket to
prevent it from being lost.
2. Place the rubber bracket pad on the camera housing,
and line up the capve screws with the holes.
3. Next, mount the bracket hinge on the underside of
the camera by using the small/shallow Phillips screws
included in a small plasc bag that may be found in
the packaging.
4. Before ghtening the bracket to the camera housing,
slide it up and down the housing unl you can li the
camera by the bracket, and nd that it is balanced. A
balanced camera will make the later mounng process
much easier.
5. If your camera is equipped with an IR illuminator, you
can plug it into one of the two power sockets at this
me. The other power socket will be used by the solar
panel input.
Antenna
Connecon
Solar Panel
Connecon
IR Illuminator or
Supplamental
Solar Panel
Connecon