User's Manual

MicroPower Technologies
1-877-536-0128 | micropower.com
20
System Administraon
Changing The Login and User Accounts, Saving Conguraons, Factory Default
Edit Login: This secon allows the operator to password protect the video streams and camera sengs. (Note:
password protecng the video streams may compromise VMS compability, depending on the make and model)
Add User: Adds new users to the system, allowing the administrator to secure the box, and allow specic intended
people access o make changes, or see the sengs.
Sengs: Allows the operator to save the current hub conguraon to their local computer, or, to load a saved
conguraon le to a hub. This can be used to restore a conguraon to a hub that has been factory defaulted.
Factory Default: Clears the sengs in a hub, and returns it to the factory default sengs.
NOTE: Remote users should be certain to check the “preserve IP Sengs” opon, so that aer the factory default,
the programmed IP address will sll remain in the system. Otherwise, the hub will return to it’s default IP address
of 192.168.0.100, and potenally become inaccessible from a remote connecon.
System Logs: This feature will save the system logs that are stored in the hub. The log data contains informaon
about the performance of the hub, signal strengths, charge levels, etc. (No images or video clips are stored or
transmied) This informaon is useful to provide to MicroPower for trouble shoong purposes.
System Logs Daily Sync: If the hub has internet access, checking this box will instruct the system to upload the log
data nightly to the MicroPower oces. This is useful in the event of a problem, MPT will already have the previous
nights logs on hand for review and analysis. “Send Log to MicroPower” will cause the system to immediately being
uploading the log data to the MPT oces for analysis and troubleshoong.